How To Fix A Punched Door Lock

My daughter has a 2000 excursion and some wonderful person punched the passenger door lock the door will not lock or unlock now.

How to fix a punched door lock.

Insert the punchplug into the lock holder black side down. In some instances the lock is still good as well as the handle and all you have to do is pull your door panel and snap the lock cylinder back in place. My passenger door lock was punched how do i fix it. The lock usually comes un coded not keyed so you will have to have it coded to your existing key.

Estimates are about 350 600 bucks 600 carstar because they have to weld then paint. If the door is warped use a couple of two by fours and a couple of clamps overnight. The repair is quick and easy. The threaded hole in the back brace is not centered on the strip.

You just have to buy a new door handle assembly and you ll probably be able to use the old lock. Wash the excess glue off with hot water the next day and paint any scratches. But worse yet to get in they punched the drivers side door lock all the way in. Leah demostrates how to repair a hole in a hollow core interior door using low pressure foam insulation and plastic wood putty.

Tighten the hinge screws and then try adjusting the strike plate by loosening its screws and shifting it slightly. 1a auto shows you how to repair install fix change or replace a broken damaged worn or faulty ignition lock key cylinder. It is held in by a spring clip and can only go in one way. Whats the best way to fix it.

Insert the back brace strip through the slots where the lock retaining clip was located. If not you ll have to buy a replacment for that as well. I recommend getting a set of jimmy jammers to prevent it from happening again i ended up putting them in both the front and rear doors as you can pop the door handles out if even if there is no keyhole. Do i have to replace the acuator and e.

This video is applicable to th. Door lock doesn t latch properly when a door latch doesn t click into position it usually means the latch and the strike plate are out of alignment. Could i just use jb weld and just have that cylinder stuck in place forever then.