Install a panel cutting blade a laminate blade or a cabinetmaker s crosscut blade on a table saw.
How to cut mdf wall panel.
You ll need basic diy skills and a couple of days to fit it and you might have to swallow a few preconceptions about faux period panels.
Hold a metal straight edge against the cut line and lightly run the utility knife blade over the line.
I worked out i wanted three panel features so brought four sticks of this decorative moulding for 5 25 each.
Laminated mdf can also be cut with either a circular saw or a jig saw.
The table saw features a platform to steady the panels as you cut.
Raise the blade to 1 inch from the tip of the highest tooth to the point where the blade emerges.
To make life easier we cut that panel down into a narrower strip which would be covered on both ends by mdf boards.
The first hurdle was to get the mdf board onto the wall even though the first hurdle was really trying to get this board home in my fiat 500 i measured the wall and cut the board to size with a hand saw.
Wall panelling is cheaper and easier to fit than tiles and less frustrating than hanging wallpaper.
Repeat this numerous times until the laminate is completely scored.
To make straight cuts in your mdf acquire a circular saw that has a cutting speed between 3 000 and 3 350 metres per second 9 800 and 11 000 ft s.
If using either of these score the laminate before cutting.
Make a paper template of any openings.
A table saw fitted with a fine tooth wood blade is a good choice for making lengthwise cuts called ripping in wall paneling.
This will act as a straight edge and give you the best cut for paneling.
Place the template on the panel in the correct location and trace around it with a pencil.
Attach a sturdy blade to a circular saw.
Snap a chalk line to get your cutting line in place and then clamp two guide boards to the paneling just wide enough apart to allow the sabre saw to run between them.
For the best cut possible install a blade that has at least 60 teeth and a width of about 355 mm 14 0 in.
Cut openings make cutouts for any wall plates outlets or electrical boxes in panels as needed using a saber saw equipped with a fine cutting blade.