1 14 operation the aqua rite is an automatic chlorine generation system for pool or spa sanitation.
Hayward low salt system manual.
Before adding large quantities of salt it is advisable to have your salt level profession ally checked.
To reset the average salt level follow the steps outlined on pg 8 or wait 24 hours for the system to acclimate to the recent changes.
If the salt level is not high verify that the cell is set to the correct cell type then reset follow steps on pages 6 and 7.
If salt level is above the range partially drain pool and or spa and refill with fresh water to achieve a salt level of 3200ppm.
Lighting equipment hayward salt swim owner s manual.
Operation and installation manual.
These levels are low enough that it normally will not be tasted.
To luxurious salt water.
Salt system 32 pages.
Each inch of water drained will reduce the salt level 100ppm maximum current amps before shutdown is 4 0 amps.
Check salt when flashing the salt level is low below 2700 ppm and aqua rite is generating at low efficiency.
Before adding large quantities of salt it is advisable to have your salt level professionally checked.
Verify salt level is 2700 3400ppm and check with independent test to ensure accuracy.
Rule of thumb.
Conductive debris may cause an unwanted.
Maximum current amps before shutdown t cell 3 7 00 t cell 9 10 00 t cell 5 10 00 t cell 15 10 00 unlike low salt the system does.
Check salt level in pool spa.
Led on cont although debris such as calcium typically cause low salt reading and not high ones it is still recommended to clean out the cell.
The operation requires a low concentration of salt sodium chloride in the pool water.
Get support by contacting us online.
Pool upgrade convert your pool.
When illuminated steady the salt level is too low and aqua rite has shut down.
For detailed instructions on resetting the inspect cell message refer to pg.
If salt level is low add salt according to chart on page 4.
Chlorine generator for inground swimming pools up to 25 000 gallons 25 pages.
With fresh water to achieve a salt level of 3200ppm refer to page 10 step 2a.