You will want to go to each smoke alarm in your home and press the circle button on it to reset it.
Hard wired smoke detector beeping intermittently.
Replace the face of the detector and listen for the chirping sound.
If that smoke alarm is the culprit all of the beeping will stop.
3 take out its battery then press the test button holding it down for 15 seconds.
This chirping will continue for at least a week if you don t change the batteries.
You can also use a mild detergent to eliminate any dust buildup.
Take the smoke detector off its mounting bracket on the ceiling and disconnect the power cable plugged to the smoke detector.
Turn the power off to the hard wired smoke detector at the circuit box.
Remove the face of the alarm.
If there s a lot of dust build up try using a mild detergent to help remove it.
Smoke alarms are often out of sight and out of reach.
If the smoke detector is beeping irregularly with no discernible pattern it s probably not the battery.
An alarm will sound for a short time then the alarm will silence.
Remove the face of the detector.
Typically smoke alarms are hardwired on the same circuit and once one smoke alarm begins beeping they will all start beeping.
Normally one smoke alarm is the cause of the beeping.
Replace the face of the detector and listen for the chirping sound.
Follow these steps to clean your detector.
Turn off power to your wired smoke detector at the circuit box.
Smoke detectors are built to chirp when the battery needs to be changed including backup batteries for hard wired alarms.
Use a vacuum or a small brush to clean out the smoke detector.
Old or broken smoke detector.
All of the beeping can make it hard to think straight.
Then wait to see if the beeping stops.
Here s how you can clean the dust from out of your smoke detector to stop it from beeping for no reason.
Use a vacuum hose or a small brush to clean out all of the dust.
On hardwired smoke detectors you may need to press and hold the reset button to make the chirping noise stop.