50 3 358 25 3 358.
Ground rod resistance tester.
Using an earth electrode tester instead of a clamp on tester will take a lot more time and effort.
Nearly all electricians and electrical inspectors are familiar with the national electrical code requirement in sec.
Unfortunately it seems many electrical professionals.
The clamp on ground tester induces the ground rod with an ac signal that is then picked up by a receiving coil within the same clamp and uses the difference to calculate the resistance.
In practice for a residential structure most electricians place two ground rods and call it done.
Fully auto ranging with data hold to capture readings.
If it is higher then you must place a second ground rod.
There is no requirement to retest the resistance.
P2 and c2 connect to a separate all metallic grounding point like a water pipe or building steel.
Reads ground resistance down to 0 10 ω.
This is a different tool from the clamp on multimeter which only reads ac current.
With this method the resistance of two electrodes in a series is measured by connecting the p1 and c1 terminals to the ground electrode under test.
250 54 which requires the resistance to ground of a single made electrode e g ground rod to be 25 ohms or less.
Measure grounding circuit performance without disrupting service.
You are correct that the nec states that if you use one ground rod that the resistance to ground must be 25 ohms.
Built to withstand an entire spectrum of ground testing methods fluke s family of earth ground testers have been designed to be accurate safe and easy to use.
This type of tester is usually available at hardware and home improvement stores as well as from online retailers.
Resistance should be less than 25 ohms if the system is connected properly.
Touch one lead to your test wire and the other lead to your test location for example an outlet s third ground plug which is the small round hole at the bottom of the outlet.
This is an older type of resistance meter that uses multiple ground probes and wires to assess a ground rod s resistance.
In areas where driving ground rods may be impractical the two point method can be used.
The clamp ground tester is clamped around one of the electrodes and then measures the resistance of the entire loop.
The remaining ground electrodes are all in parallel and as a group are in series with the ground electrode being measured.
The easiest way for you to measure the resistance of a ground rod is to use a clamp on ground tester.
