Ground Rod Hammer Bit

During operation the sleeve traveled up the shank past the end of the shank.

Ground rod hammer bit.

The electrical code states that it must have 8 feet 2 4 m of contact with the ground so you need to drive it all the way down. The inner diameter of the driver was tight on my 5 8 ground rod but i figured it would be fine. Ground rod into the ground by hand. For hard hitting demolition hammer accessories look to grainger for quality bits chisels and more.

Rod setting tool te pd 2224565. Designed to work in hammer mode. Demolition hammer bit 4 demolition tool 5 flat chisel 10 floor scraper 2 ground rod driver 5 hammer hauler 1 moil point 2 moil point chisel 1 narrow chisel 2 rock breaker 2 sds max demolition tool 11. I had to cut the ground rod to remove the driver.

I really like this ground rod driver it sure beats sledge hammering a 8 ft. And made of high quality forged steel. Now the ground rod is stuck in the driver. Ground rod into place.

At this point there was nothing to keep the bit on the ground rod causing a fall accident due to the bit traveling off of the ground rod causing an injury. Drove the rod all the way in with my bosch 36v hammer drill. Safer and easier assembly of the hilti power ground rod driving system. I could have never completed this job without the bosch rh432vcq 1 1 4 inch sds plus rotary.

The hammer drill or rotary hammer makes driving an 8 foot copper ground rod easy and fast. I like that this tool makes short work of driving a 5 8 in. Drive the rod into the ground. Spkline sds plus ground rod driver for 5 8 inch and 3 4 inch ground rods 13 16 x 6 11 16 20x170mm 10mm diameter shank fits bosch dewalt milwaukee hilti and other sds plus rotary hammer drills bosch hs1914 18 in.

I like that the overall length is 10 in. Ground rod driver for grounding and earthing applications using a demolition hammer. For 5 8 rod buy the 3 4 size driver. Bosch offers a full assortment of sds max hammer steel points and chisels.

Using your hammer drill or driving tool gradually drive the rod vertically into the ground. The sleeve of the bit is not welded to the shank only pressed on. Just got to use this for the first time.